Belling BE813 Installation And User Instructions Manual

Belling BE813 Installation And User Instructions Manual

Fully integrated larder

Advertisement

BE813
Fully Integrated Larder
INSTALLATION AND USER INSTRUCTIONS
You must read these instructions prior to using the
appliance and retain them for future reference.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BE813 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Belling BE813

  • Page 1 BE813 Fully Integrated Larder INSTALLATION AND USER INSTRUCTIONS You must read these instructions prior to using the appliance and retain them for future reference.
  • Page 3: Table Of Contents

    Contents Introduction & safety warnings...2 Electrical requirements ...3 Transportation instructions...4 Installation instructions...5 Repositioning the door ...6 Suggested arrangement of food in the larder fridge...8 Temperature control and adjustment...9 Starting ...10 Defrosting...10 Cleaning and care ...11 Replacing the interior light bulb...12 Do's and don'ts...13 Problem solving/trouble shooting ...13 Installation instructions - detailed step by step ...14...
  • Page 4: Introduction & Safety Warnings

    • Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally. • If you are discarding an old refrigerator with a lock or latch fitted to the door, ensure that it is left in a safe condition to prevent the entrapment of children.
  • Page 5: Electrical Requirements

    ELECTRICAL REQUIREMENTS Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply. Rating label is on the left hand side of fridge liner. We recommend that this appliance is connected to the mains supply via a suitable switched and fused socket in a readily accessible position.
  • Page 6: Transportation Instructions

    TRANSPORTATION INSTRUCTIONS 1. The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation. 2. If during the course of transport the appliance has to be transported horizontally, it must only be laid on its left hand side when standing in the front of the appliance.
  • Page 7: Installation Instructions

    IMPORTANT INSTALLATION INSTRUCTIONS 1. To avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instructions. 2. Do not operate this appliance unless installed to furniture. 3. The appliance should be located on a smooth surface. The four front and back feet can be adjusted as required.
  • Page 8: Repositioning The Door

    REPOSITIONING THE DOOR Follow the step by step instructions and the diagram below. Numbers in brackets refer to diagrams.
  • Page 9 1. Switch off at the socket outlet and pull out the mains plug. 2. Remove all food, loose items and fittings from inside the appliance and door shelves. 3. Unscrew the bolts and remove the upper and bottom hinges from the cabinet and door.
  • Page 10: Suggested Arrangement Of Food In The Larder Fridge

    SUGGESTED ARRANGEMENT OF FOOD IN THE LARDER FRIDGE Arrangement Examples (See diagram). 1. Baked, chilled cooked food, dairy products. 2. Meat, sausages, cold cuts, cans. 3. Fruit, vegetables, salads. 4. Tubes, small bottles and cans. 5. Egg tray. 6. Butter, cheese, dairy products. 7.
  • Page 11: Temperature Control And Adjustment

    8. Keep the food packed, wrapped or covered. Allow hot food and beverages to cool before placing them in the fridge. Do not store explosive substances in the refrigerator. High proof alcohol must be stored upright in sealed containers. Left over canned food should not be stored in the can.
  • Page 12: Starting

    STARTING Final Check Before you start using the refrigerator check that: 1. The feet have been adjusted for perfect levelling. 2. The interior is dry and air can circulate freely. 3. Clean the interior as recommended under "CLEANING AND CARE."...
  • Page 13: Cleaning And Care

    ** Make sure that no water enters the temperature control box. ** If the larder refrigerator is not going to be used for a long period of time switch it off, remove all food, clean it and leave the door ajar.
  • Page 14: Replacing The Interior Light Bulb

    REPLACING THE INTERIOR LIGHT BULB (See diagram) Should the light fail to work switch off at the socket outlet and pull out the mains plug. Follow the instructions below to check if the light bulb has worked itself loose. If the light still fails to work obtain a replacement E14 screw cap type 15 Watt (Max) bulb from your local electrical store and then fit it as follows: 1.
  • Page 15: Do's And Don'ts

    Don't- Store melon in your fridge. It can be chilled for short periods as long as it is wrapped to avoid it flavouring other food. Don't- Leave the door open for long periods as this will make the larder refrigerator more costly to run.
  • Page 16: Installation Instructions - Detailed Step By Step

    INSTALLATION INSTRUCTIONS - DETAILED STEP BY STEP NOTE 1) Height of the product can be adjusted by the help of adjustable feet (front and back) to fit the furniture niche height (B). 2) Do not operate this appliance until it has been installed in the furniture. A (mm) 813 - 863 mm B (mm)
  • Page 17 C=100-150 mm D > 150 mm.
  • Page 19 E = 1,5 mm is recommended. Top view B = 25 mm minimum. Front view Note: 1. These dimensions are valid for products,which are hinged on right hand side. 2. When door opening direction is reversed, mirror image of this instruction should be considered.
  • Page 22: Guarantee Details

    GUARANTEE DETAILS Your new Belling product is guaranteed against the cost of breakdown repairs for twelve months from the date of the original purchase. What is covered? • Repairs necessary as a result of faulty materials, defective components or manufacturing defect. •...
  • Page 23: How To Obtain Service

    problem solving section This product bears the selective sorting symbol for waste electrical and electronic Recycling equipment (WEEE). This means that this product must be handled pursuant to European Directive 2002/96/EC in order to be recycled or dismantled to minimize its impact on the environment. For further information, please contact your local or regional authorities.
  • Page 24: Technical Data

    PERFORMANCE Energy efficiency class Energy consumption - Kwh/year Net storage - vol fresh food ltrs (cu.ft.) Net storage - vol frozen food ltrs (cu.ft.) Total net vol - ltrs (cu.ft.) Frozen food compartment rating Conservation time from failure Freezing capacity fresh food - kg Climate class Operating noise level dB(A) Technical data...
  • Page 25: Wiring Diagram

    WIRING DIAGRAM...
  • Page 28: Customer Care

    BELLING CUSTOMER CARE In case of difficulty within the UK, please call Belling Customer Care Centre Helpline on When you dial this number you will hear a recorded message and be given a This indicates that your call has been accepted and is being held in a queue. Calls are answered in strict rotation as our Customer Care Representatives Enter appliance numbers here for future reference: Please ensure you have the above details (Model No and Serial No) to hand...

Table of Contents

Save PDF