Installation And Set-Up; Installing The Wbsn-2400-S Base Station - Wavion WBSn-2400 Quick Start Manual

Installation and Set-up

The following section describes the installation and configuration procedures for your WBSn-2400-O or
WBSn-2400-S base station, that will enable the establishment of a basic set-up.
Further information regarding configuration procedures and information will be available in the
User Guide
.

Installing the WBSn-2400-S base station

Prior to performing the procedures described in this section, ensure that you have read all the information,
and followed all instructions and safety precautions in the
To install WBSn-2400-S:
1. Decide the manner in which the post-clamp will be attached to the post, whether horizontally or
vertically.
Note: If you wish to install WBSn-2400-S on a horizontal plane, you need to include special extenders in
your order.
Example: Horizontal post-clamp
2. Slide the steel bands into the appropriate side slots of the post clamp.
Note: For a thinner post, the steel bands should be threaded through the inner slots, and for a wider
post, through the outer slots.
3. Attach the post-clamp to the post, and close and tighten the steel bands.
Example: Steel bands tightened around a post
4. If you are installing the WBSn-2400-S on a vertical post, attach the WBSn-2400-S unit to the post-
clamp, with the screws and washers. Tighten the screws using a ratchet key, set at 13 mm, and proceed
to this step.
5. If you are installing WBSn-2400-S on a horizontal post, select the direction in which the base station unit
should point on the horizontal plane prior to continuing with the installation.
6. Once you have ascertained the correction direction, connect the two extenders to the post clamp.
7. Attach the WBSn-2400-S base station unit and connected extenders to the base station unit.
WBSn attached with extenders
WBSn-2400 Quick Start Guide
Pre-Installation Checklist.
WBSn-2400
Page 8