Encryption Methods; Radio Configuration (Basic); Vlan Configuration - Wavion WBSn-2400 Quick Start Manual

Encryption Methods

Legacy 802.11 clients can either connect using the Open authentication (see above), or WEP. In WEP, the
encryption key can be either 40bit or 104bit. In WPA, WBSn-2400 supports TKIP encryption.
In order to support legacy clients, (supporting only WEP), WBSn-2400 enables the TSN (Transient Security
Network) mode, which allows VAPs that support both WEP and TKIP clients. In this case, the broadcast key
is WEP, while the unicast key is either TKIP or WEP, depending on the manner in which the client is
connected to the system.
Note: When you configure a TSN VAP, key #1 is used by TKIP, and you should therefore configure the WEP
key as key #2.
Security Mode
None
WEP
WPA
WPA2

Radio configuration (basic)

To configure the radio settings, navigate to Configuration => Wireless => Radio. Select the required
channel bandwidth and specify the parameters, as described in the following table.
Note: Only 2.4 GHz is available for this WBSn release. 5.0 GHz will be available for future releases.
Field
Radio
Channel/Frequency [MHz]
Wireless System Mode
TX Power

VLAN configuration

1. To specify a new VLAN, navigate to Configuration => Network => Bridge.
2. Expand the VLANs Configuration window, and click Add to configure the VLAN Parameters. A pop-up
box with the following parameters is displayed.
Parameter
VLAN ID
VLAN Tagging
VLAN Name
3. Scroll back up to the VLANs section, and specify a VAP for the VLAN.
WBSn-2400 Quick Start Guide
Authentication Mode
Open system
• Shared key
• PSK (Pre-shared key)
Radius
•
PSK (Pre-shared key)
•
Radius
•
Mixed mode PSK
•
Mixed mode Radius
•
• Mixed mode PSK + Radius
Description
Specify that the radio waves are operational, or turn them
off for purposes such as a maintenance.
Specify the channel/frequency
Specify the wireless system mode:
Data
•
Video Surveillance
•
• VOIP
Custom
•
Specify the transmission power
Description and values
This ID should be unique and must be supported by the backbone equipment
that is connected to the WBS through the Ethernet port.
Ensure this is enabled.
Edit the VLAN name as required.
Encryption Mode
None
• WEP/40
WEP/104
•
• TKIP
TKIP+WEP/40
•
TKIP+WEP/104
•
AES
•
AES + TKIP
•
Page 14