Step 6; Step 7 - Flexispot H2S Installation Manual

Step 6

Evenly place the work surface onto the legs then attach it to the side brackets (6, 7) using
screws (H). Tighten screws firmly with a drill or screwdriver.
6
H
06
7
E
Use the gaskets (E) while screw the cross bar (4),
using gasket (E) quantity depends on the length
of your desktop.

Step 7

Attach the crank handle holder (10) to the underside of the table top using 2 screws (H). Ensure
that the crank handle will properly settle onto the holder when pushed in before screwing crank
handle holder (10) to surface.
Place the crank here after you use.
10
H
07