Maintenance And Troubleshooting; Specifications - Baumr-AG HD2 User Manual

20V Cordless Hammer Drill / Driver HD2

Maintenance and Troubleshooting

Remove the battery from the tool before performing any maintenance. • The machine should
be cool enough to touch before performing maintenance activities. • Some maintenance
activities described may be beyond the scope of some users. For procedures that you are not comfortable
with or have the tools or experience for, have the unit serviced by a service centre or qualified technician.
•
Clean the tool regularly with a soft cloth – do NOT use water, solvents, abrasives etc. Remove any
debris from the chuck and tool ventilation slots using a soft brush.
The following information may assist in identifying a problem and rectifying it.
Drill will not operate.
Possible Fault
No voltage
Direction not correctly selected
Drilling / Screwing is poor.
Possible Fault
Low voltage
Bit dull or damaged
Material too hard, cutting speed or
mode incorrect
Incorrect torque
Excessive vibration.
Possible Fault
Bit dull, bent or damaged

Specifications

Battery Charger Electrical Requirements
Battery Type
Drilling Speed
Chuck Capacity
E&OE
Action
Ensure the battery is charged
Ensure that the direction selector
Action
Ensure the battery is charged.
Sharpen or replace drill bit.
Use correct drill bit for the material and operating mode.
and material hardness. For hammer drilling, use "hammer" mode and high speed.
Adjust torque to suit screw diameter and material.
Action
Sharpen or replace drill bit.
240VAC / 50Hz
20V Lithium-Ion
0 to 350 RPM – Speed 1 / 0 to 1300 RPM – Speed 2
10mm
© 2017 Bäumr-AG
and is correctly inserted.
is properly set.
Adjust speed to suit drill diameter
9