Advertisement
3. Top of the work (It needs two or more people operations, and some people care)
4. Other ways: Operators can flexibility use, but must consider security.
Ⅳ Safe use and maintenance
Safety Instructions
1. Users must comply with the instructions
2. Area must be clean, light.
3. Balance body when use tool.
4. Let the idle and the children away from work place.
5. Avoid the wires, water, gasoline.
6. In general workplace, it need security measures, such as power failure protection, leakage
protection, safety isolation transformer, or the user must wear insulated gloves and insulated mat
insulation.
7. Do not exchange the plug type.
8. After use, remove the plug in time.
9. To prevent a sudden start, insert the plug, the drill and magnet control switch should be in off
position
10. Far away from power supply over 20m, you need select our factory cable tray (S333, S4332
with leakage protection)
Help
1. Use voltage, line voltage specified on the nameplate does not exceed ± 5% voltage
2. According to models equipped with the appropriate drill chuck or taper sleeve, specifically for
the use of three-jaw drill chuck Φ13mm, Φ19, Φ23 with No.2 Morse taper sleeve, Φ32, Φ38, Φ49,
Φ60, Φ80 use Morse taper sleeve 4 # number. Insert taper shank into the shaft .
3. The drill must be sharp. When drill brake suddenly, you must immediately close the drill control
switch (Note: Do not drill off magnet control switch)
4. Brush can not be used .It needs timely exchange brush
5. When magnet drill can not use, it should immediately be repaired.
6. Magnet drill must be kept clean.
7. Do not impact magnetic drill.
8. 3 hours continuous use, the magnet should rest for moment in order to prevent magnet
overheating and burn.
Maintenance
1.Add oil frequently and keep gear box and bearing clean.
2. Maintain magnetic drill frequently, such as: check magnet suction, drill, power plugs, lights,
switch, insulation, resistance whether normal, the guide plate movement whether normal.
3. Save each part.
4. Magnet drill should be stored upright in a dry, clean and no corrosive gas environment.
3
Advertisement
