Table of Contents
Advertisement
Quick Links
Electric Core Drill with Base
User Manual
[Revision 4.0 October 2017]
READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY
DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by
this manual may vary in appearance, assembly, inclusions, specifications, description and packaging.
E&OE
©2017 Bäumr-AG
Advertisement
Table of Contents
Related Manuals for Baumr-AG DRLDICBMRAV30
Summary of Contents for Baumr-AG DRLDICBMRAV30
- Page 1 Electric Core Drill with Base User Manual [Revision 4.0 October 2017] READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by this manual may vary in appearance, assembly, inclusions, specifications, description and packaging.
-
Page 2: Safety
Electric Core Drill with Base Safety Read and understand all safety warnings before using the tool. • Avoid dangerous environments. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite dust or fumes. •... - Page 3 Electric Core Drill with Base • When using water as coolant, do NOT allow water to get into the motor. • Overhead drilling is allowable only when suitable safety measures are taken (water collection etc). • Stop working if water starts dripping from overrunning bore hole. Take machine to be serviced. •...
-
Page 4: Table Of Contents
Electric Core Drill with Base Table of Contents Safety ..............................2 Table of Contents ..........................4 Set-Up and Operation ........................5 Ground Fault Circuit Interrupter (GFCI)...................... 5 Extension Leads ............................5 Tool Set-Up ..............................5 Water Connections ..........................6 Fastening the Base ..........................6 Overload Protection ........................... -
Page 5: Set-Up And Operation
Electric Core Drill with Base Set-Up and Operation Ground Fault Circuit Interrupter (GFCI) The machine MUST be connected to a properly earthed 240VAC mains electrical socket. Do NOT use the machine with a non-earthed electrical supply. Do NOT use the machine with an extension cord that is not properly earthed. -
Page 6: Water Connections
Electric Core Drill with Base Water Connections The water pressure should not exceed 3 bar (43PSI). • Always ensure that the tool is operated with sufficient water supply, as the seals can be damaged if run dry. This could lead to leakage of water into the gearbox housing –... -
Page 7: Drill Bits
Electric Core Drill with Base Drill Bits • Drill bits with a 1-1/4” UNC female thread can be screwed directly to the tool spindle. • Always use drill bits that are appropriate for the material you will be drilling. You can extend the life of the tool by using drill bits that are not damaged or deformed. -
Page 8: Maintenance
Electric Core Drill with Base Maintenance Procedures not specifically explained in this manual must be performed by qualified technicians only . • Before performing any inspection, maintenance, or cleaning procedure, place the motor switch in the "OFF" position and disconnect the machine from the electrical supply. -
Page 9: Troubleshooting
Electric Core Drill with Base Troubleshooting Problem Possible Cause Possible Solution / Recommendations Overload protection A. Bit has insufficient cutting clearance. A. Replace bit. tripping B. Feed rate too high. B. Reduce load. Low penetration rate A. Drilling rebar (steel) - fluid not muddy. A. - Page 10 Electric Core Drill with Base Some experts believe that the incorrect or prolonged use of almost any product may cause serious injury or death. To help reduce your risk of serious injury or death, refer to the information below. For more information, see www.datastreamserver.com/safety Consult all documentation, packaging and The product has been supplied by a general merchandise...