Batteries And Battery Charging; Charging; Inserting And Removing The Battery Pack; Battery Charge Status - Baumr-AG HD2 User Manual

20V Cordless Hammer Drill / Driver HD2

Batteries and Battery Charging

Batteries for this tool are supplied in a low-charge condition for shipping reasons. • A battery that is
new or has not been used for a long period does not charge to full capacity until after approximately
5 charge/discharge cycles. • Do not recharge batteries after using them if they are not to be used for an
extended period of time. • Recharge batteries only as and when required. • If the battery is warm after use,
allow it to cool before charging, otherwise it may not fully charge.
The battery packs can be recharged again and again. However, rechargeable batteries eventually need to
be replaced. A significantly reduced working period after charging indicates that the battery is no longer
serviceable and should be replaced. Discard old batteries in an environmentally responsible manner.

Charging

The battery charger has a charge status LED indicator:
•
Red - Battery charging.
•
Green - Battery fully charged.
1. Plug the battery charger power supply into a 240VAC mains
electrical outlet and switch the supply ON.
2. Slide the battery fully into the battery charger. The indicator LED on the battery charger will be red to
show the battery is charging. The indicator will become green when the battery is fully charged
(approximately 1 to 1.5 hours).
3. When the battery is fully charged, unplug the charger from power supply, then press and hold the
battery release button and simultaneously slide the battery pack from the charger.

Inserting and Removing the Battery Pack

Insert the battery pack into the tool handle until it "clicks" into place.
To remove the battery pack, press and hold the battery release button
(A) and simultaneously pull the battery from the tool.

Battery Charge Status

The drill has 3 coloured indicators (B) for battery charge status – green, yellow and red. The charge status is
shown when the drill is operated (trigger (C) pulled). Status is:
•
Green + Yellow + Red – Battery fully charged.
•
Green + Yellow – Battery charge approximately 50%.
•
Red – Battery close to fully discharged.
E&OE © 2017 Bäumr-AG
A
B
C
6