Declaration of Electromagnetic Compatibility (EMC)
Medical electrical equipment needs special precautions regarding EMC and needs to be
installed and put into service according to the following information:
The RM500SL should not be used adjacent to or stacked on other equipment. If this is
•
necessary, its operation should be verified as normal in this configuration.
Portable and mobile RF communications equipment can affect medical electrical
•
equipment and may affect the performance of the RM500SL.
The RM500SL has not been tested for immunity to electromagnetic disturbances.
•
Performance degradation due to such disturbances (including electrostatic discharge)
is considered normal and acceptable.
The compliances listed in the following table are met with the Audioscan SL-100 RECD
transducer connected. The use of other accessories may result in increased emissions.
Guidance and manufacturer's declaration - electromagnetic emissions
The RM500SL is intended for use in the electromagnetic environment specified below.
The user of the RM500SL should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage
fluctuations/
flicker emissions
IEC 61000-3-3
User's Guide Version 3.4 © June 2011
RM500SL
®
Compliance
Group 1
Class A
Class A
Complies
Electromagnetic environment -
guidance
The RM500SL uses RF energy only for
internal function. Therefore RF emissions
are very low and not likely to cause any
interference
in
equipment.
The RM500SL is suitable for use in all
establishments other than domestic and
those directly connected to the public low-
voltage
power
supplies
buildings
purposes.
8
nearby
electronic
supply
network
used
for
domestic
that