I/O And Audio Connector; Multicable Connectors - Axis Q6054 Mk II Installation Manual

AXIS Q60 Series
NO TICE TICE
NO NO TICE
The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the network shall be intended for their specific use. Make sure that the
network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Electromagnetic compatibility (EMC) 2.
SD card slot
NO TICE TICE
NO NO TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects or excessive force when
inserting or removing the SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product
is running. Disconnect power or unmount the SD card from the Axis product's webpages
before removal.
This product supports SD/SDHC/SDXC cards (not included).
For SD card recommendations, see www.axis.com

I/O and audio connector

Terminal connector for connecting external equipment:
• Audio equipment
• Input/Output (I/O) devices
When connecting external equipment, an Axis multicable is required in order to maintain the
product's IP rating. For more information, see Multicable connectors on page 24.

Multicable connectors

When connecting external equipment to the Axis product, an Axis multicable is required in order to
maintain the product's IP rating. The Axis multicable can be purchased from your Axis reseller. To
locate the multi-connector, see Hardware Overview on page 9.
The multicable provides the following connectors:
Power connector - 3-pin terminal block used for power input. Use a Safety Extra Low Voltage
(SELV) compliant limited power source (LPS) with either a rated output power limited to ≤100 W or
a rated output current limited to ≤5 A.
Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is
used from a stereo signal).
Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address
(PA) system or an active speaker with a built-in amplifier. A stereo connector must be used for the
audio out.
24