Installing A 1 (Ru) Chassis In A Four-Post Rack - Cisco Nexus 36180YC-R Hardware Installation Manual

Installing a 1 (RU) Chassis in a Four-post Rack

To inspect the switch, follow these steps:
Step 1 Compare the shipment to the equipment list provided by your customer service representative and verify that you have
received all items, including the following:
• Grounding lug kit
• Rack-mount kit
• ESD wrist strap (found in the Accessory Kit)
• Cables with connectors
• Optional items ordered
Step 2 Check for damage and report any discrepancies or damage to your customer service representative. Have the following
information ready:
• Invoice number of shipper (see the packing slip)
• Model and serial number of the damaged unit
• Description of damage
• Effect of damage on the installation
• Photos of the damaged shipping containers and damaged product
Step 3 Check to be sure that all of the fan and power supply modules have the same airflow direction.
• Port-side intake airflow direction indicated with burgundy coloring
• Port-side exhaust airflow direction indicated with blue coloring
Installing a 1 (RU) Chassis in a Four-post Rack
This section describes the rack installation for the Cisco Nexus 3016, 3048, 3064T, 3064-32T, 3064-X, 3132Q,
3132Q-X, 3172PQ, 3172TQ, 3232C, 3524P-10G, 3524P-10GX, 3548P-10G, 3548P-10GX, and 36180YC-R
chassis.
Step 1 Install the two front-mount brackets to the switch as follows:
a) Determine which end of the chassis is to be located in the cold aisle as follows:
• If the switch has port-side intake modules (fan and AC power supply modules with burgundy coloring and DC
power supply modules with green coloring), position the module so that its ports will be in the cold aisle.
• If the switch has port-side exhaust modules (fan and AC power supply modules with blue coloring), position
the module so that its fan and power supply modules will be in the cold aisle.
Cisco Nexus 3600 Hardware Installation Guide
10
Installing the Chassis