Configuring The Wireless Telephone; Configuring The Network Parameters - Intermec MobileLAN User Manual

MobileLAN voice System User's Guide
To change the menu settings
1. Use the arrow keys to navigate to the menu display screen number (1-4) that you
2. Type the information that you want to display on each line of the menu.
3. Press Enter to save the entries.
4. Repeat Steps 1, 2, and 3 for each menu as needed.
To restore factory defaults
•

Configuring the Wireless Telephone

Before you can configure a MobileLAN voice 2 wireless telephone, you must associate
it with one and only one line on a telephony gateway. For help, see "Associating the
Wireless Telephone Lines" earlier in this chapter.
These instructions assume that the wireless telephone has been properly associated with
a line on a telephony gateway. While wireless telephones are being associated, the
wireless telephone system will continue normal operation.
Use the Wireless Device Planning Worksheets to make sure that you are correctly
assigning telephone parameters.

Configuring the Network Parameters

You need to use the Admin menu to assign the IP address and ESSID for the wireless
telephone so that it can communicate with the LAN and with the access points. You
may also need to set WEP encryption.
However, the Admin menu also lets you restore the factory defaults of the wireless
telephone and use the wireless telephone to check signal strength.
To configure the network parameters
1. With the wireless telephone turned off, press and hold the PWR key and then press
2. Release the PWR key, then release the END key. The first option on the Admin
3-22
want to edit and press Enter.
Use the arrow keys to navigate to Restore Factory Defaults and press Enter.
the END key.
menu appears.