Configuring The Telephony Gateway (First Time); Connecting To The Telephony Gateway Via The Serial Port - Intermec MobileLAN User Manual

MobileLAN voice System User's Guide

Configuring the Telephony Gateway (First Time)

For the initial configuration of each MobileLAN voice telephony gateway, you should
have the Wireless Device Planning Worksheet(s) that was filled out during installation.
There should be one worksheet for each telephony gateway. You need to know these
parameters before proceeding with the setup:
•
•
•
•
The initial setup of each telephony gateway requires establishing its IP address on the
LAN. You need to perform this task using a serial connection. Intermec recommends
that you also configure other basic setup parameters at this time. Perform these steps on
each telephony gateway.
1. Connect to the telephony gateway via the serial port.
2. Select the telephony gateway.
3. Configure the telephony gateway.
4. Reset the telephony gateway.

Connecting to the Telephony Gateway Via the Serial Port

1. Connect the telephony gateway to the serial port of a PC or terminal using a DB-9
2. On your PC, run a terminal emulation program (such as HyperTerminal) or use a
3. Press Enter to display the login screen.
4. Type the default login: admin and the default password: admin. These fields are
The Gateway Connection Selection screen appears and lists the telephony gateway and
its factory default name.
3-6
Hostname (usually the default name is replaced with a locally-designated identifier)
IP address (established by the system administrator)
PBX (Private Branch Exchange) type
Number of phones per access point
female, null-modem cable (Part No. MCI100).
VT100 terminal with this configuration:
Baud rate 9600
Data bits 8
Parity None
Stop bits 1
Flow control None
case sensitive.