Table of Contents
Advertisement
AL-M320DN/AL-M310DN/AL-M220DN User's Guide
Using the Control Panel
When to make control panel
settings
In general, printer driver settings override settings made
using the control panel.
You should make the following settings by using the
control panel because these settings cannot be made in
the printer driver.
❏ Settings to select emulation modes and IES
(Intelligent Emulation Switching) mode
❏ Settings to specify a channel and configure the
interface
❏ Settings to specify the size of the memory buffer
used to receive data
For AL-M220DN, which does not have an LCD panel,
you can do the control panel settings using EpsonNet
Config. See
"How to access the control panel menus
(AL-M220DN)" on page
17.
How to access the control panel
menus (AL-M320DN/
AL-M310DN)
Note:
Some menus and items appear only when a
corresponding optional device is installed or an
appropriate setting has been done.
A
Press the r Right button to access the control
panel menus.
B
Use the u Up and d Down buttons to scroll
through the menus.
Getting to Know Your Printer
C
D
E
F
How to access the control panel
menus (AL-M220DN)
Although there are no panels that can display menus,
you can do settings that correspond to the operation
panel menus from a computer that is connected to the
printer. You can do the settings using the following
procedure.
From EpsonNet Config (web version)
You can do settings when the printer is connected to the
network.
The method to open the settings screen is shown below.
17
Press the r Right button to view the items in a
menu. Depending on the menu, the LCD panel
displays an item and the current setting
separated ( YYYY=ZZZZ), or only an item (
YYYY).
Use the u Up and d Down buttons to scroll
through the items, or press the l Left button to
return to the previous level.
Press the r Right button to carry out the
operation indicated by an item, such as printing a
configuration status sheet or resetting the
printer, or to view the settings available for an
item, such as paper sizes or emulation modes.
Use the u Up and d Down buttons to scroll
through available settings, then press the r Right
button to select a setting and return to the
previous level. Press the l Left button to return
to the previous level without changing the
setting.
Note:
❏ You need to turn the printer off and then on
to activate the settings you changed in the
Network Menu, USB Menu or RAM Disk in
the Setup Menu.
❏ The OK button can be used instead of the
r Right button in step 3 or 5.
Press the l Left button once or more times to exit
the control panel menus.
Hide quick links:
Advertisement
Table of Contents
