Related Manuals for Maytag HK521B
Summary of Contents for Maytag HK521B
- Page 1 Bottom Freezer Refrigerator " (6.35 mm) Trim and Handle Conversion Kits Installation Instructions HK521B HK521S HK521W HTK531B HTK531S HTK531W...
- Page 2 Decorator Panel Dimensions RECOGNIZE THIS SYMBOL Listed below are required height and width dimensions for AS A SAFETY PRECAUTION decorator panels. Panels are not supplied with this kit but can be purchased locally. WARNING CAUTION To avoid electric shock which can cause severe To avoid personal injury or property damage, total panel personal injury or death, observe the following: weight on a single door should not exceed 30 pounds...
- Page 3 Procedure Reversing Refrigerator Door WARNING If door is not being reversed, proceed to "Installing Refrigerator Handle, Trim, and Door" section. To avoid electric shock which can cause severe 1. Remove cabinet plugs with flat blade screwdriver tip personal injury or death, observe the following: wrapped in masking tape.
- Page 4 Installing Refrigerator Handle, Trim, and 8. Install door extension on top of refrigerator door using 1/4" (6.3 mm) hex head screws. Door 9. Install top trim on refrigerator door using T-15 Torx ®* 1. Remove handle plugs from sides of door. screws.
- Page 5 3. Pull upper basket out to full extension and lift up to Installing Handle and Pullout Drawer remove. 1. Remove hole plugs from side of drawer. 2. Install clips on both sides of drawer. 3. Install bottom trim on drawer using T-15 Torx ®* screws.
- Page 6 8. Pull both rails out to full extension. 9. Hook door supports into rail tabs, as illustrated, and lower door into final position. 10. With drawer pulled out to full extension, insert lower basket by aligning tabs on both side of lower basket with notches in rail assembly.
- Page 8 Part No.12685909 © Maytag Appliances Sales Co. 2002 Printed in U.S.A. 9/02...