3-1. Using the touch screen
The initial screen
To avoid damaging the touch screen
■
Touch the screen lightly with your finger. If there is no response, remove your fin-
●
ger from the screen and try again.
Remove any dirt on the screen by wiping with a soft cloth. Do not use detergent.
●
When using the touch screen
■
If the screen is cold, the display may be dark, or the system may seem to be
●
operating slightly slower than normal.
The screen may seem dark and hard to see when viewed through sunglasses.
●
Change your angle of viewing, adjust the display on the "Display" screen or
remove your sunglasses.
314
If the "ENGINE START STOP" switch
is turned to ACCESSORY or IGNI-
TION ON mode, the initial screen will
be displayed for a few seconds as the
system starts up.