WAGO smartPRINTER Operating Instructions Manual page 20

smartPRINTER Operating Instructions
Fig. EE5

Adjust the media guide to the width of the label material.
The print material bulges if the media guide is set too narrow.
The print material escapes from the media guide if it is set too wide.
An incorrectly adjusted media guide leads to errors in the transport of the print medium and
the printed image.

Feed the label material through under the hold-down device (not in the figure) and the media
guide.

Pull the label material the length of one label out of the printer in the direction of the print
roller.
Abb. EE5
7. Check whether the label roll can turn freely on the holder in the printer.
8. The label roll must not rest on the printer housing. The side of the print media that is to be
printed on must face upwards.
Close the smartPRINTER. Hold the lock button down. Guide the printer top onto the printer bottom.
Press the top until the housing parts lock audibly, which is signaled by a click.
smartPRINTER Operating Instructions 003/10.2017
20