Table of Contents
Advertisement
Leave all components inside the static-proof packaging that they shipped
with until they are ready for installation. Use correct screws and do not over
tighten screws.
Jumper Setting
A jumper is the simplest kind of electric switch. It consists of two metal pins
and a cap. When setting the jumpers, ensure that the jumper caps are
placed on the correct pins. When the jumper cap is placed on both pins,
the jumper is short. If you remove the jumper cap, or place the jumper cap
on just one pin, the jumper is open.
Refer to the illustrations below for examples of what the 2-pin and 3-pin
jumpers look like when they are short (on) and open (off).
Two-Pin Jumpers: Open (Left) and Short (Right)
Three-Pin Jumpers: Pins 1 and 2 are Short
CONFIDENTIAL: The information contained herein is proprietary and confidential information of Barco.
be disclosed in any form or by any means and/or stored in a data base or retrieval system without the prior written consent of Barco and/or used for any
purpose other than authorized by Barco.
Interactive Patient Care – Barco Healthcare Division
No part of the information contained herein may
Advertisement
Table of Contents
