Operating Modes; Setup; Definitions; Browsing - Espa SPEEDRIVE Instruction Manual

If necessary, reconnect the display cable to the motherboard.
Give special attention to positioning.
Single Single- - - - Phase Version
Single Single

4) OPERATING MODES.

4) OPERATING MODES. 4) OPERATING MODES. 4) OPERATING MODES.
Automatic mode. Automatic mode. Automatic mode. Automatic mode.
This is the common operating mode.
The inverter controls the motor's rotation speed to maintain a constant pressure in the installation (set pressure).
Manual mode. Manual mode. Manual mode. Manual mode.
Allows the pump start-up or stop manually at an adjustable frequency.

5) SETUP.

5) SETUP. 5) SETUP. 5) SETUP.
Espa ESD pumps and Espa pressure booster sets are pre- - - - configured in origin with an optimum pressure set Espa ESD pumps and Espa pressure booster sets are pre Espa ESD pumps and Espa pressure booster sets are pre Espa ESD pumps and Espa pressure booster sets are pre
point for equipped pumps. Do not need any further adjustment. point for equipped pumps.
point for equipped pumps. point for equipped pumps.
Speedrive module purchased separately, is necessary its configuration, according to the following paragraphs.

5.1) Definitions.

5.1) Definitions.
5.1) Definitions. 5.1) Definitions.
Set pressure: is the pressure that the unit will maintain in the installation. Set pressure: Set pressure: Set pressure:
Differential pressure: Differentia Differentia Differentia l pressure: l pressure: l pressure: is the differential pressure required for the unit to activate again.
Stop frequency: frequency at which the inverter stops the pump. Stop frequency:
Stop frequency: Stop frequency:
Stop delay: Stop delay: timer used by the unit before it stops.
Stop delay: Stop delay:
Auxiliary "on Auxiliary Auxiliary Auxiliary "on "on- - - - off" pump: "on off" pump: off" pump: auxiliary pump that is not equipped with Speedrive. off" pump:
Auxiliary Auxiliary Auxiliary Auxiliary regulated pump: regulated pump: auxiliary pump that is equipped with a Speedrive. regulated pump: regulated pump:

5.2) Browsing.

5.2) Browsing.
5.2) Browsing. 5.2) Browsing.
Screen displaying
See description on screen
Flashing = pump waiting
Fixed = pump operating
Power supply plug-in
Browsing the menus.
Variation of the flashing parameter.
Browsing a submenu.
Phase Version
Phase Version Phase Version
Do not need any further adjustment.
Do not need any further adjustment. Do not need any further adjustment.
the menus
Failure
Three- - - - Phase Version Three
Three Three
configured in origin with an optimum pressure set configured in origin with an optimum pressure set configured in origin with an optimum pressure set
- 9 -
Phase Version
Phase Version Phase Version
Browsing keys