Description Of The Menus - Espa SPEEDRIVE Instruction Manual

Accepting changes.
Return to the general screen from display of parameters.
Pressure: 2.0bar
View Menu
5.3)

5.3) Description of the menus.

Description of the menus.
5.3) 5.3) Description of the menus. Description of the menus.
START SCREENS START SCREENS
START SCREENS START SCREENS
MAIN SCREEN MAIN SCREEN MAIN SCREEN MAIN SCREEN
MANUAL OPERATION MANUAL OPERATION
MANUAL OPERATION MANUAL OPERATION
CONFIGURATION CONFIGURATION CONFIGURATION CONFIGURATION
Backlight Backlight
Backlight Backlight
The screen is backlit display for better reading.
To save power, the backlight turns off in 60 seconds without pressing any keys.
To activate the backlight, press OK
Without backlight does not work any other key.
Introduction screen Introduction screen Introduction screen Introduction screen
Displayed during a few seconds when connecting the equipment.
Indicates: model, software version and pressure sensor configuration.
Start screen Start screen
Start screen Start screen
The pump is not activated.
To start the pump manually, press ► (Man)
For automatic operation, press ◄ (Auto)
To configure parameters, press ▼ (Config)
It shows the system pressure. The pump will run automatically, as needed.
To display parameters, press ◄ (View)
To return to the start screen, press ► (Menu)
It shows the system pressure and Speedrive output frequency.
Press ▲ ON, to activate the pump. Start-up is always performed at 15Hz.
Press▼ OFF, to stop the pump.
Press◄ or ►, to adjust the frequency.
Press O O O O K K K K to exit the screen.
Screen descriptions:
Top : parameter being configured.
-
Lower left : current value of the parameter.
-
Lower right, "flashing": new value being configured. Press OK
-
LANGUAGE LANGUAGE LANGUAGE LANGUAGE
Select the desired language.
MOTOR FREQUENCY MOTOR FREQUENCY MOTOR FREQUENCY MOTOR FREQUENCY
Configuration of the nominal frequency of the motor, 50Hz or 60Hz.
Check the motor's nameplate.
Note: This screen only appears in the initial preset or retrieving the factory
settings.
MAXIMUM PUMP HEIGHT MAXIMUM PUMP HEIGHT
MAXIMUM PUMP HEIGHT MAXIMUM PUMP HEIGHT
Setting the maximum pressure the pump can provide.
Check the pump's nameplate.
Note: This screen only appears in the initial preset or retrieving the factory settings
OK.
OK OK
- 10 -
OK OK to confirm. OK