Test Operation; Test Operation Using Pcb (Outdoor Unit); Test Operation Using Remote Controller; Check List - Fujitsu ARXC36L Installation Manual

00 Enable
01 Disable
Filter
indicator 13 Display
action only on
02 central
remote
control
00 Default
Horizon-
tal swing
24
01 Left half
airflow
direction
02 Right half
00 Default
Cool air
tem-
30
01 Adjust (1)
perature
trigger
02 Adjust (2)
00 Default
Hot air
01 Adjust (1)
tem-
31
perature
02 Adjust (2)
trigger
03 Adjust (3)
00 Enable
Auto
40
restart
01 Disable
00 Start/Stop
External
46
control
Emergency
01
stop
00 All
Error
Display
report 47
only on
target
01 central
remote
control

8. TEST OPERATION

] 1
8.1. Test operation using PCB (Outdoor
unit)
• Refer to the Installation Manual for the outdoor unit if the
PCB for the outdoor unit is to be used for the test operation.

8.2. Test operation using remote controller

• Refer to the Installation Manual for the remote control unit to
perform the test operation using the remote control unit.
• When the air conditioner is being test run, the OPERATION
and TIMER indicator lamps flash slowly at the same time.
For details, please refer to the Manual of "IR Receiver Unit" or
"Wired Remote Controller".
○
Enable or disable the filter
indicator. Setting 02 is for use
with a central remote control.
○
Adjust the horizontal swing airflow
direction.
(For horizontal swing equipped
models)
○
Adjust the cool air trigger
temperature. To lower the trigger
temperature, use setting 01. To
raise the trigger temperature, use
setting 02.
○
Adjust the hot air trigger
temperature. To lower the trigger
temperature by 6 degrees C, use
setting 01. To lower the trigger
temperature by 4 degrees C, use
setting 02. To raise the trigger
temperature, use setting 03.
Enable or disable automatic
system restart after a power
○
outage.
Allow an external controller to
○
start or stop the system, or to
perform an emergency shutdown.
* If an emergency shutdown is
performed from an external
controller, all refrigerant systems
will be disabled.
○
Change the target for reporting
errors. Errors can either be
reported in all locations, or only
on the wired remote.

9. CHECK LIST

Pay special attention to the check items below when
] 1
installing the indoor unit(s). After installation is complete, be
sure to check the following check items again.
Check items
Has the indoor unit
been installed correctly?
Has there been a
check for gas leaks
(refrigerant pipes)?
Has heat insulation
work been completed?
Does water drain easily
from the indoor units?
Is the voltage of the
power source the same
as that indicated on the
label on the indoor unit?
Are the wires and
pipes all connected
completely?
Is the indoor unit
grounded?
Is the connection cable
the specified thickness?
Are the inlets and outlets
free of any obstacles?
After installation is
completed, has the
proper operation
and handling been
explained to the user?
If not performed
correctly
Vibration, noise,
indoor unit may drop
No cooling, No heating
Water leakage
Water leakage
No operation, heat
or burn damage
No operation, heat
or burn damage
Short circuit
No operation, heat
or burn damage
No cooling, No heating
Check
box
En-13