Error Codes - Fujitsu ARXC36L Installation Manual

10. ERROR CODES

If you use a wired type remote control, error codes will appear
] 1
on the remote control display. If you use a wireless remote
control, the lamp on the photodetector unit will output error
codes by way of blinking patterns. See the lamp blinking
patterns and error codes in the table below.
Abnormal display
OPERATION TIMER
indicator indicator
lamp (green) lamp (orange)
(1) (2)
(1) (4)
(1) (6)
(3) (1)
(3) (2)
(4) (1)
(4) (2)
(5) (1)
(5) (3)
(9) (15)
Display mode : 0.5s ON / 0.5s OFF
: 0.1s ON / 0.1s OFF
( ) : Number of flashing
Wired Remote Controller Display
For details on marking the ERROR CODES, please refer to
the Manual of "IR Receiver Unit" or "Wired Remote
Controller".
En-14
Wired
Remote Abnormal
FILTER
Controller contents
indicator
Error code
lamp (red)
Remote control
abnormal
communication
Anomalous
network
communications
Abnormal parallel
communication
Abnormal power
frequency
Abnormal model
information
/ abnormal
EEPROM
accession
Abnormal room
temperature
thermistor
Abnormal indoor
heat exchanger
temperature
thermistor
Abnormal indoor
fan motor
Abnormal
drainage
Abnormal
outdoor unit
Error code