Table of Contents
Advertisement
suitable plug to the 3-pin AC supply lead. The colours of the wires conform to the
internationally recognised standard such that:
IMPORTANT – THE INSTRUMENT MUST BE EARTHED.
The green/yellow wire in the AC supply must be connected to a properly grounded
terminal.
If a compressor and/or pen recorder is to be run directly from the instrument then they
should be wired to the plugs provided and connected to the POWER OUT sockets (15a
and 15b).
Press the power switch on the front panel. The digital readout should be illuminated.
3. Fill the centre tube of the drain trap and the connecting silicon rubber tubing to the
mixing chamber with deionised water. Check that no air bubbles are trapped in this tube
and that it flows and runs to waste freely. Ensure that the drain trap is pushed
completely down on its clip.
2.5
Accessories
Always use recommended spares and accessories. Even if an alternative part may appear
obviously suitable there may be some minor variations in specification that could degrade the
performance of the instrument.
Accessory
Model 8515 air compressor (220V 50Hz)
Model 8516 air compressor (110V 60Hz)
Dilutor 230V
Dilutor 110V
Analogue to RS232 Data Logger
Calcium filter
Lithium filter
Barium filter
Butane regulator
Propane regulator
Natural gas regulator
Water separator (small)
Water separator (large)
Dust cover
Cleaning solution (1 litre)
Minor spares kit
Major spares kit
BROWN
BLUE
GREEN/YELLOW
10
LIVE
NEUTRAL
EARTH
Part Code
535 001
535 002
037 001
037 002
037 501
500 125
500 126
500 127
500 178
500 179
500 180
500 176
500 177
500 134
025 171
500 172
500 173
PFP7/REV C/01-08
Advertisement
Table of Contents
