Table of Contents
Advertisement
PRECAUTIONS
1. Check the accuracy of the product each time before starting your work.
For details, see "CHECKING THE ACCURACY".
2. Avoid heavy shake or impact on the product.
The product is designed in an impact-resistant structure. However
excessive impact may cause degradation in performance. After heavy
impact, an accuracy check should be carried out.
3. Before moving this product, lock this product by turning the power OFF.
After work is finished, turn the power switch OFF. Then the product is
locked internally.
4. If there is an apparent abnormality, do not use this product.
Immediately stop work, and contact the store of purchase or the nearest
Makita sales office.
5. If the laser is not emitted after turning the power ON, lightly shake this
product a few times.
If the laser is not emitted even after shaking this product lightly a few
times, immediately stop work, and contact the store of purchase or the
nearest Makita sales office.
6. When the power is turned ON, the product emits the laser beam in the
same mode that was turned OFF last time. Operate the switch with
keeping the laser beam away from your eyes.
7. In dark area, reflections may be seen besides the regular laser lines.
8. Do not use the product if condensation is found on it.
Do not turn the power ON. Leave the product until condensation naturally
disappears.
9. Do not use the laser receiver near the point the laser lines cross each
other. The laser receiver does not detect near such a point.
10. When transporting this product, put it in its case.
11. When storing, put the product in its case. The storage area should be
away from heat, moisture, vibration and dust.
12. Clean the glass at exit opening of the laser beam using soft cloth to keep
performance.
13. When the product is dirty, wipe it clean with a soft, dry cloth. If the dirt is
stubborn, use a cloth moistened with water and wrung firmly. Then, wipe
off any water again with a soft, dry cloth. Do not use alcohol, benzene,
pain thinner, or other volatile solvents. (Doing so might cause discoloring,
deformation, alteration or other abnormalities.)
14. Do not wash the product. It may cause malfunction.
10 ENGLISH
Advertisement
Table of Contents
