2. Operating the power switch
[Power ON]
Turn the power switch to the "I/ON" side. The laser beam is emitted. The laser beam is
emitted in the mode that was active when the product was turned OFF last time.
[Power OFF]
Turn the power switch to the "O/OFF" side. The power turns OFF, and the pendulum
inside is locked. After turning the power OFF, disconnect the battery or DC jack.
3. Brightness selection
Select the brightness of the emitted line beam by the brightness selection switch on the
operation panel.
When the power is turned ON, the laser beam is emitted in the Bright mode.
1. Power switch
1
Brightness selection switch
18 ENGLISH