Advertisement
Quick Links
DO NOT PRINT THIS PAGE
Material: 20 Pound (US) or 80 GSM (International) bound paper, white
Ink: Black
Resolution: 150 DPI or above
Printing method: Offset Printing
Binding: Saddle Stitch
Folded size: 5.5 x 8.5 in (W x H)
This drawing contains proprietary information and trade secrets of The Coleman Company, Inc.
METRIC
[INCH]
CRITICAL DIMENSION
CHECKING IS COMPULSORY
VOLUME
01
cm3
MASS
grams
REV.
MATERIAL:
SEE NOTES
DENSITY
g/cm3
GENERAL TOLERANCES
EXCEPT AS NOTED
SEE NOTES
FINISH
SPEC.:
0 TO
6mm = ±0.1
>6 TO
30mm = ±0.2
SCALE:
>30 TO
80mm = ±0.3
1:1
>80 TO
180mm = ±0.4
>180mm
= ±0.5
NAME:
INSTRUCTION MANUAL, SUP ENGLISH
ANGULAR
= ± 3°
Printing Notes:
Unauthorized use or copying is prohibited.
18-JUN-13
NEW
DATE
MODIFICATIONS
DATE:
DRAWN BY:
18-JUN-13
Rainy X
Program: InDesign CS4
Black
Rainy X
NAME
The Coleman Company, Inc.
Wichita, Kansas USA 67219
SHEET 1 OF 1
COMPOSITE- NO
APPROVED BY:
CB
PART
NO.:
4010026068
s
20029769
ECN NO.
REVISION
01
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Sevylor INFLATABLE STANDUPPADDLEBOARD
Summary of Contents for Sevylor INFLATABLE STANDUPPADDLEBOARD
- Page 1 Program: InDesign CS4 Black DO NOT PRINT THIS PAGE Printing Notes: Material: 20 Pound (US) or 80 GSM (International) bound paper, white Ink: Black Resolution: 150 DPI or above Printing method: Offset Printing Binding: Saddle Stitch Folded size: 5.5 x 8.5 in (W x H) This drawing contains proprietary information and trade secrets of The Coleman Company, Inc.
- Page 2 ® ® INFLATABLE STANDUP PADDLEBOARD READ THE FOLLOWING INSTRUCTIONS AND WARNINGS TO AVOID DROWNING OR SERIOUS INJURY WARNING: • Read owners manual before using this product. • Not a life saving device. • Not for use by children. • Always wear an approved Personal Flotation Device (Life Preserver).
-
Page 3: Important Information
IMPORTANT INFORMATION The warnings below relate to various situations. Please observe them. CAUTION! Denotes an imminent hazard which will result in severe injury if you do not comply with the instructions. WARNING! Reminds you of safety measures which must be observed. Also denotes unsafe practices which could result in personal injury or damage to the product or property, if you do not comply with the instructions. - Page 4 CAPACITY & WARNINGS WARNING! Do not exceed the certified maximum capacities under any circumstances! Persons Capacity Maximum Payload Capacity Model # Persons Only Persons & Gear Inflation Pressure Inflatable Standup Paddleboard 1 Pers. or 250 lbs. 250 lbs. 10.0 to 12.0 PSI CAUTION! Do not over inflate.
- Page 5 FIN ASSEMBLY FOR BOARDS WITH 1 REMOVABLE FIN: This fin may be added before or after inflation. To attach, slide fin into slot on the bottom of board. Once in place lock into place using the locking pin. Removable Locking Pin FIN ASSEMBLY FOR BOARDS WITH 3 REMOVABLE FINS: Before inflating, affix the fins to the fittings on the bottom of the board.
- Page 6 INFLATION The inflatable is equipped with a rugged high pressure valve. Please familiarize yourself with it before you start inflating. The valve has a screw-in cap attached with a Nylon cord. Unscrew the cap and expose a notched center post. This is where you lock and open the valve.
- Page 7 CARE & STORAGE • Deflate the board. Remove the 3 fins. Leave the valve open while you roll it up towards the valve. • Close the valve to prevent moisture and debris from being sucked inside as the air re-enters while you let go of the board. •...
- Page 8 NOTES: ®...
- Page 9 ® © 2013 The Coleman Company, Inc. All rights reserved. Sevylor are registered trademarks of The Coleman Company, Inc. ® ® ® ® 3600 North Hydraulic • Wichita, KS 67219 U.S.A. 1-800-835-3278 • www.Sevylor.com 4010026068 (ECN20029769-01)
Need help?
Do you have a question about the INFLATABLE STANDUPPADDLEBOARD and is the answer not in the manual?
Questions and answers