Page 1
® I NFLATABLE BOATS Including the following Model Series: Pacifica™, Willamette™, Columbia™, Sunburst™ and Colossus™ READ THE FOLLOWING INSTRUCTIONS AND WARNINGS TO AVOID DROWNING OR SERIOUS INJURY WARNING: • Not a life saving device. • Not for use by children without adult supervision.
Page 2
IMPORTANT INFORMATION The warnings below relate to various situations. Please observe them. CAUTION! Denotes a imminent hazard which will result in severe injury if you do not comply with the instructions. WARNING! Reminds you of safety measures which must be observed. Also denotes unsafe practices which could result in personal injury or damage to the product or property, if you do not comply with the instructions.
WARNING! Never use a compressor, CO or compressed air to inflate the boat. Do not let your boat come into contact with sharp, pointed objects. To inflate using any Sevylor QuickPump™ unit: ® To begin inflation, Attach adapter hose...
® instructions above, using the mini Double Lock™ valve adapter. The mini Double Lock™ valve adapter is included with all Sevylor ® pumps. The adapter can be purchased from Customer Service by calling 1-800-835-3278 (Part Number 5010000707).
Page 5
Do not attempt to mount a motor on any boat that does not state a Max. HP Engine rating. WARNING! The “Pacifica™ 2 Person Boat” and the “Sunburst™ 3 Person Boat” are not NMMA Certified. Do not overload these two boats. Do not attempt to attach a motor to these two...
SEVYTEST™ GAUGE Some of the Sevylor products are equipped with a Sevytest™ ® gauge. The Sevytest™ device is a pressure gauge, not an infl ation gauge. The Sevytest™ gauge is found on the side wall, inside the main chamber(s). The purpose is to show you when to let some air out after the pressure has increased due to temperature change.
Sevylor 12V Trolling Motor, Model 2000004144 without purchasing ® any additional mounting hardware. Refer to 12V Trolling Motor mounting instructions. Mounting any motor other than the Sevylor 12V Trolling Motor, ® Model 2000004144, requires the Sevylor Motor Mount Kit, Model ®...
GRAB LINE INSTALLATION: IMPORTANT: To properly install the inflatable boat’s grab line, first inflate the boat. Feed the grab line through the eyelets on each of the rope holders. Then tie the two loose ends in a square knot at the rear of the boat.
Page 9
AirSeal is intended for use with 100% PVC (poly vinyl chloride) only. Do not use with any other material. You may purchase the Sevylor repair patch (Model # 2000003731) ® and Sevylor AirSeal (Model # 2000003730) by calling Coleman ® Customer Service at 1-800-835-3278 or going to www.sevylor.com.
Coleman or an authorized service center. Further, the warranty does not cover Acts of God, such as fire, flood, hurricanes and tornadoes. Warranty void if damage to the product results from the use of a part other than a genuine Sevylor part.