Set Mv Sensor Type - Honeywell XNX Technical Manual

XNX Universal Transmitter
Figure 72. Set Time Screen
Use the switches to navigate to the ü� Select it to save the
changes� If ü is not selected, no changes will be saved�
Figure 73. Accept Time-Date Changes
When the new settings have been saved, the "Settings
Accepted" screen will be displayed�
Figure 74. Time-Date Settings Accepted
The remainder of this section requires Level 2 security access.
Section 2 - Installation and Operation

Set mV Sensor Type

Figure 75. Set mV Sensor Type Screen
Set mV Sensor Type sets the identity of the type of mV sensor
attached to the transmitter� The available mV sensor type
selections are:
Sensor
MPD-IC1 (5%V) MPD Carbon Dioxide 5%Vol
MPD-IV1 (5%V) MPD Methane 5%Vol
MPD-IV1 (100%L) MPD Methane 100%LEL
MPD-IF1 (100%L) MPD Flammable 100%LEL
MPD-CB1 (100%L) MPD Flammable 100%LEL
705-HT (20%L) 705 Flammable 20%LEL (High-Temp)
705-HT (100%L) 705 Flammable 100%LEL (High-Temp)
705-STD (100%L) 705 Flammable 100%LEL
SP-HT (20%L) Sensepoint Flammable 20%LEL (High-Temp)
SP-HT (100%L) Sensepoint Flammable 100%LEL (High-Temp)
SP-STD (100%L) Sensepoint Flammable 100%LEL
SP-PPM (10%L) Sensepoint Flammable PPM (10%LEL equiv)
SP-PPM Sensepoint Flammable PPM
SP-HT-NH3 Sensepoint Ammonia 30,000 PPM
59
Description