6
Security & NAT
Click Security & NAT to configure firewall and
NAT-releated settings.
Firewall Settings
Click Firewall Settings to configure firewall related
functions.
SPI Firewall
By default, SPI Firewall is Enabled. Choose Disable and
click Apply to disable the firewall function; but please be
noted that the firewall protection will be lost, and any packet
inspections and filtering features won't take effect.
Ping from WAN Filter
By default, it is Enabled. Choose Disable and click Apply to
enable the ping from WAN.
MAC/IP/Port Filtering
Click MAC/IP/Port Filtering to set up filtering fules for
protection against virus, worm and malicious activity on
the Internet.
18
Choose Always to activate the configuration of
1
filtering services. The default value is Never and no
filering rules can be added in this page.
Enter the following values as required:
2
Source MAC Address: To specify the MAC address from
which to deny data transmission.
Destination/Source IP Address: To specify IP address to
deny data transmission.
Protocol: Here provides three default policies for security
levels for you to choose.
Dest/Source Port Range: The port range is from 0 to 65535.
Please key in the start point and end point for the Filtering.
Click Apply to create the filtering rule; or Cancel to give
3
up the previous settings; or Delete Selected after
selecting specific entry to delete the filtering rule.
Port Forwarding
Click Port Forwarding to configure the virtual serve to
1