Technical Support - Tinkerine Studio DITTO PRO Quick Start Manual

STARTING A PRINT
MAIN
MENU
Print
Axis Wizard
From the main menu, turn the dial to scroll to Print.
1
Push down on the dial to select.
Whenever you begin a print, always check that the rst layer of the print is properly stuck onto the blue painter's tape. A
properly leveled bed should have the extruded lament a bit squished and shouldn't pop off the bed easily. While the
printer is performing the skirt nozzle purge, observe the deposited lament and make micro-adjustments with the thumb-
screw if necessary.
TOO CLOSE
Visit our printer registration page to complete and submit the registration form to apply your Tinkerine Product Warranty.
Follow the instructions listed on the website to complete your production registration.
For technical assistance, please contact the Tinkerine Technical Support team:
Temp
Status
LEVELED
PRINTER REGISTRATION
http://warranty-registration.tinkerine.com

TECHNICAL SUPPORT

• Email: contact@tinkerine.com
• Phone: 1-604-288-8778
MAIN
TEST_PRINT.G
VASE.G
BRACELET.G
YOUR_PRINT.G
Scroll down to the le you want to print and push
2
down again to start the print.
TOO FAR