Tinkerine Studio DITTO PRO Quick Start Manual page 3

Thread the lament through the guide tube. Push
4
the tensioner button down to make it easier to thread
the lament through the drive gear and into the hotend.
Trim off the tip of the lament with a pair of scissors if you are having trouble feeding the lament into the hotend.
INSTALLING THE PRINT BED
Place the glass print surface onto the bed with the
1
blue painter's tape side facing upward. The tape
will act as an adhesion material for the plastic.
Replace any worn or damaged blue painter's tape as needed to ensure that your prints stick properly during the
printing process.
STARTING THE PRINT BED CALIBRATION
MAIN
MENU
Axis
From the main menu, turn the dial to scroll to Wizard.
1
Push down on the dial to select.
Print Temp
Status
Wizard
Once the lament is inserted all the way down into
5
the hotend, insert the guide tube into the top of the
extruder cap.
With the clips provided in the kit, slide each clip on
2
to pinch the bed platform and glass print surface
together. Attach the clips onto the bed as shown.
WIZARD
Bed Level
Exit
Select the Bed Level option and follow the
2
on-screen instructions to level the printer's bed level.
New Filament