Settings; Information For Test Institutes - Neue IDSH603W User Manual

Programme
4)
1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes
can change the values.
2) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery with nor-
mal soil. (This is the standard programme for test institutes).
3) With this programme you can wash a load with fresh soil. It gives good washing results in a short time.
4) Use this programme to quickly rinse the dishes. this prevents the remaining food to bond on the dishes and bad odours to
come out from the appliance. Do not use detergent with this programme.

Information for test institutes

For all the necessary information for test performance,
send an email to:
info.test@dishwasher-production.com

Settings

Programme selection mode and user mode
When the appliance is in programme selection mode it
is possible to set a programme and to enter the user
mode.
In user mode, the following settings can be
changed:
• The level of the water softener according to the
water hardness.
• The activation or the deactivation of the acoustic
signal for end of programme.
These settings will be saved until you change them
again.
How to set the programme selection mode
The appliance is in programme selection mode when all
the programme indicators are on.
When you activate the appliance, usually it is in
programme selection mode. However, if this does not
Water hardness
German degrees
(°dH)
47 - 50
6
Degree of soil Programme phases
Type of load
•
All
French degrees
(°fH)
84 - 90
Duration
(min)
Prewash
14
Write down the product number (PNC) that is on the
rating plate.
happen, you can set the programme selection mode in
the following way:
Press and hold the programme button until the
appliance is in programme selection mode.
The water softener
The water softener removes minerals from the water
supply, which would have a detrimental effect on the
washing results and on the appliance.
The higher the content of these minerals, the harder
your water is. Water hardness is measured in equivalent
scales.
The water softener should be adjusted according to the
hardness of the water in your area. Your local water
authority can advise you on the hardness of the water in
your area. It is important to set the right level of the
water softener to assure good washing results.
mmol/l Clarke de-
8.4 - 9.0
Consumption values
1)
Energy
(kWh)
0.1
Water softener level
grees
58 - 63
Water
(l)
4
10