Neue IDSH603W User Manual page 13

Problem and alarm code
The appliance does not drain the water.
• The end indicator flashes 2 times intermit-
tently.
• Acoustic signal sounds 2 times intermittently.
The anti-flood device is on.
• The end indicator flashes 3 times intermit-
tently.
• Acoustic signal sounds 3 times intermittently.
The appliance stops and starts more times during
operation.
Small leak from the appliance door.
The appliance door is difficult to close.
Rattling/knocking sounds from inside the appli-
ance.
The appliance trips the circuit-beaker.
Refer to "Before first use", "Daily
use", or "Hints and tips" for other
possible causes.
Once you have checked the appliance, deactivate and
activate the appliance. If the problem occurs again,
contact an Authorised Service Centre.
The washing and drying results are not satisfactory
Problem
Poor washing results.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
• Close the water tap and contact an Authorised Service Cen-
tre.
• It is normal. It provides optimal cleaning results and energy
savings.
• The appliance is not levelled. Loosen or tighten the adjusta-
ble feet (if applicable).
• The appliance door is not centred on the tub. Adjust the rear
foot (if applicable).
• The appliance is not levelled. Loosen or tighten the adjusta-
ble feet (if applicable).
• Parts of the tableware are protruding from the baskets.
• The tableware is not properly arranged in the baskets. Refer
to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneously all the
appliances in use. Check the socket amperage and the ca-
pacity of the meter or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Author-
ised Service Centre.
For alarm codes not described in the table, contact an
Authorised Service Centre.
Possible cause and solution
• Refer to "Daily use", "Hints and tips" and basket loading leaflet.
• Use more intensive washing programmes.
Clean spray arm jets and filter. Refer to "Care and Cleaning".
•
Possible cause and solution
13