Table of Contents
Advertisement
Caution! An incorrect position of the
filters can cause bad washing results
and damage to the appliance.
Cleaning the spray arms
Do not remove the spray arms. If the holes in the spray
arms are clogged, remove remaining parts of soil with a
thin pointed object.
Troubleshooting
If the appliance does not start or it stops during
operation, before you contact an Authorised Service
Centre, check if you can solve the problem by yourself
with the help of the information in the table.
Warning! Repairs not properly done
may result in serious risk to the safety of
the user. Any repairs must be performed
by qualified personnel.
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
•
The end indicator flashes 1 time intermittent-
ly.
•
Acoustic signal sounds 1 time intermittently.
12
External cleaning
•
Clean the appliance with a moist soft cloth.
•
Only use neutral detergents.
•
Do not use abrasive products, abrasive cleaning
pads or solvents.
Internal cleaning
•
Carefully clean the appliance, including the rubber
gasket of the door, with a soft damp cloth.
•
If you regularly use short duration programmes,
these can leave deposits of grease and limescale
inside the appliance. To prevent this, we
recommend to run long duration programmes at
least 2 times per month.
•
To maintain the performance of your appliance at its
best, we recommend to use monthly a specific
cleaning product for dishwashers. Follow carefully
the instructions on the packaging of the product.
With some problems the end indicator flashes
intermittently indicating a malfunction.
The majority of problems that can occur can be
solved without the need to contact an Authorised
Service Centre.
Possible cause and solution
•
Make sure that the mains plug is connected to the mains
socket.
•
Make sure that there is no damaged fuse in the fuse box.
•
Make sure that the appliance door is closed.
•
The appliance has started the procedure to recharge the res-
in inside the water softener. The duration of the procedure is
approximately 5 minutes.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clogged.
•
Make sure that the inlet hose has no kinks or bends.
Hide quick links:
Advertisement
Table of Contents
