Technical Details
Troubleshooting
IMAGE IS BLURRED
Possible Causes
The Projector is not in focus
The Projector is offset from plane / angle of
operation
NO SYNC, NO SIGNAL
1.
Be sure to setup the computer to enable a video signal output. On some lap-
tops this is done by pressing and holding Function F5 key. If using the P300
Neo as an external monitor on Windows based systems, this can be done by se-
lecting "extend my desktop to this monitor". The native resolution of the P300
Neo projector is 1280x720. Depending on the video driver different resolutions
may need to be selected for proper output.
Chapter 5
Solution
Adjust the focus with the focus adjustment dial
until the image comes into focus
Move the projector so that it is both 180 degrees
and on an evern plane with the screen. Or it can be
adjusted by keystone settings
41