Fagor Brandt HERAKLES LA3P 001UK-0306 Manual page 31

THE HERAKLES DISHWASHER
Technical Training
Designation
Draining pump
Fan
Drying conduit
Power board
Selector and display board
Function
Evacuate waste waters and waste whose
size is smaller than the waste filter mesh.
It is fed from the power board
continuously or in fractions.
It is directly assembled to the cycling unit
and is located under level of water in the
cycling unit.
The horizontal turbine and a small-
diameter hole between the unit and the
pump facilitates its degassing and limits
the noise.
A check valve is placed in
the in the draining conduit
of the cycling unit.
Allow drying the dishes in models with
mark A as drying result.
A plastic conduit is used for directing the
airflow to the "exchanger" part of the
technical zone of models with fan-
assisted drying. It is located on the plastic
top of the tub.
Products with drying mark B have a small
technical zone and a solenoid valve
connected to a condenser built in the
plastic top of the tub.
It receives information from the access
board and sensors, feeds the power
components and also the access board
and then it returns information to the user
via the access board.
This is the power board, which stores the
programs in memory.
It transmits to the power board the user's
choices and receives from this board the
information to be displayed.
LA3P-HERAKLES-001UK-0306
COMPONENTS
Features
Synchronous motor with internal thermal
safety device.
Supply voltage: 230V~
Power: approximately 30 W
Flow rate: approximately 15 litres/minute
Ohmic value: 260Ω.
It is installed quarter-turn on the cycling
unit.
To prevent it from moving during the
appliance transport, a plastic clip
(accessible under the pump) holds it
locked on the cycling unit.
Its sucks the humid air from the tub and
the "exchanger"
then pushes it into
part of the
technical zone before
returning it into the tub.
Fan:
Supply voltage: 230V~
Ohmic value: 400Ω.
The complete fan is located in the plastic
top of the dishwasher tub.
The fan is also fed for a few seconds on
each draining in order to expel the
residual water.
It is located behind a sheet metal
crosspiece that is accessible after
removing the clipped plinth of the
dishwasher.
The selection board and display board
assembly is located behind the strip.
- 31 -