Fagor Brandt HERAKLES LA3P 001UK-0306 Manual page 24

FUNCTION
The filling of models with large technical zone
Front side
Reinforcing
pieces
Resins
Hydraulic
unit
A part of the hard water flows through a calibrated
nozzle to fill the regeneration reserve (which is only full
after several air intakes). If there iss overflow from this
reserve, the overflow flows to the tub through the tub
vent. Because, the technical zone is provided with a port
to the tub that is vented through a box located on its left
side, so ensuring the tub and air inlet venting.
The softened water flows out of the resins, flows
through the bottom of the technical zone and flows to
the hydraulic unit.
- 24 -
The water flowing out of the filling solenoid valve flows
through the technical zone bottom, to fill then (from bottom to
top) the water reserve of the exchanger (that will be used
during the drying).
This reserve is renewed on each filling and always remains
full (use a magnet to open the purge located at the bottom,
in order to empty the reserve before removing it, for
example).
Next, the water flows through the air break located at the top
of the technical zone before flowing down into the resins.
SV1
Resins
CU3P-CDC-003-02/05
LA3P-HERAKLES-001UK-0306
THE HERAKLES DISHWASHER
Air break
Water reserve
for the exchanger
Venting
- Tub
- Outside
Technical Training
Rear side
Exchanger reserve purge