Advertisement
RECHARGEABLE 2.4GHz - DX-2 STUNT DRONE
CHARGING BATTERY
Note: The Battery Charger will light up when it is
charging the battery and turn off when the
battery is fully charged. Charge time is
approximately 60 minutes.
1. Turn off the drone before charging.
2. Connect the Battery Charger Cable to the
port found on the rear of the drone
3. Connect USB connector to the power source.
INSTALLING BLADE GUARDS
• Click blade guards in place per diagrams below.
• Use provided screws and a small screwdriver to
secure the blade guards before use.
BEFORE INSTALLATION:
Printed in China.
Connect the Charge
Cable to the Drone
AFTER INSTALLATION:
Insert the USB
connector into
a USB power
source
3
Advertisement
Need help?
Do you have a question about the DX-2 and is the answer not in the manual?
Questions and answers
When the switch on drone is off, the lights on drone are blinking.. Not sure what to do? Is the drone no good? Broke in some way?
The blinking lights on the Sharper Image DX-2 drone, even when the power switch is off, could indicate an internal electrical issue. The drone may have suffered damage from the reported bump on the ceiling, potentially affecting its circuitry or power switch. This could cause residual power to keep the lights flashing. Additionally, if the drone no longer pairs with the remote, it suggests a malfunction that may require inspection or repair.
This answer is automatically generated
como cambiar las hélices del dron
To change the propellers on the Sharper Image DX-2 drone:
1. Identify the Blades: Each propeller has a number written on it. Match the new blades with the corresponding numbered positions on the drone.
2. Remove the Damaged Propeller: Carefully pull the old propeller straight up to remove it.
3. Install the New Propeller: Align the new propeller with the post and push it straight down until you hear a small click.
4. Check for Proper Installation: Ensure the propellers are securely attached and match the correct positions before flying.
This answer is automatically generated
Can I use my, smartphone to control the drone
Yes, the Sharper Image DX-2 drone can be controlled using an Android smartphone by downloading and syncing a mobile app with the drone.
This answer is automatically generated
My drone is not connecting to the remote. I'm pushing the throttle up and then down, but it is not beeping or pairing.
To fix the connection issue between your Sharper Image DX-2 drone and its remote:
1. Ensure both the drone and remote have fully charged or new batteries.
2. Turn the drone on and place it on a flat, level surface.
3. Turn on the remote.
4. Move the left joystick down, then up, then down again.
5. Wait for a beep to confirm successful pairing.
If pairing fails after following this process and the batteries are good, inspect for any loose or damaged wires inside the drone, especially near the motors or the circuit board, as a previously repaired wire could have come loose again.
This answer is automatically generated