Green Indicator Lights; White Indicator Lights; Blue Indicator Lights; Onboard Diagnostic System - Fiat 500L 2018 User Manual

Hide thumbs Also See for 500L 2018:
Table of Contents

Advertisement

If equipped with a block heater harness the
message "Engine Heater Recommended", will be
displayed in the instrument cluster when the
ambient temperature is below 5°F (-15° C) at the
time the engine is shut off as a reminder to avoid
possible crank delays at the next cold start.

Green Indicator Lights

— Cruise Control Set Indicator Light
— If Equipped
This light will turn on when the speed control is
set to the desired speed. Refer to "Speed Con-
trol" in "Starting And Operating" for further
information.
— Front Fog Indicator Light — If
Equipped
This indicator will illuminate when the front fog
lights are on.
— Park/Headlight On Indicator Light
This indicator will illuminate when the park lights
or headlights are turned on.
— Turn Signal Indicator Lights
When the left or right turn signal is activated, the
turn signal indicator will flash independently and the
corresponding exterior turn signal lamps will flash.
Turn signals can be activated when the multifunction
lever is moved down (left) or up (right).
NOTE:
• A continuous chime will sound if the vehicle is
driven more than 1 mile (1.6 km) with either
turn signal on.
• Check for an inoperative outside light bulb if
either indicator flashes at a rapid rate.

White Indicator Lights

— Light Sensor Failure
This light illuminates when there is light sensor
failure. If this light illuminates, have an authorized
dealer inspect it.
— Cruise Control On Light — If
Equipped
This light will turn on when the cruise control has
been turned on, but a speed is not selected. Refer
to "Speed Control" in "Starting And Operating"
for further information.

Blue Indicator Lights

— High Beam Indicator Light
This indicator shows that the high beam head-
lights are on.With the low beams activated, push
the multifunction lever forward (toward the front
of the vehicle) to turn on the high beams. Pull the
multifunction lever rearward (toward the rear of
the vehicle) to turn off the high beams. If the high
beams are off, pull the lever toward you for a
temporary high beam on, "flash to pass" scenario.
ONBOARD DIAGNOSTIC
SYSTEM — OBD II
Your vehicle is equipped with a sophisticated
Onboard Diagnostic system called OBD II. This
system monitors the performance of the emis-
sions, engine, and transmission control systems.
When these systems are operating properly, your
vehicle will provide excellent performance and
fuel economy, as well as engine emissions well
within current government regulations.
47

Advertisement

Table of Contents
loading

Table of Contents