Erasing All The Homelink Channels; Identifying Whether You Have A Rolling Code Or Non-Rolling Code Device; Programming Homelink To A Garage Door Opener - Fiat 500L 2018 User Manual

Ensure that your vehicle is parked outside of the
garage before you begin programming.
It is recommended that you erase all the channels
of your HomeLink before you use it for the first
time.
If you have any problems, or require assistance,
please call toll-free 1-800-355-3515 or, on the
Internet at HomeLink.com for information or
assistance.

Erasing All The HomeLink Channels

To erase the channels, follow this procedure:
1. Place the ignition switch into the ON/RUN
position.
2. Push and hold the two outside HomeLink
buttons (I and III) for up to 20 seconds, or until
the HomeLink indicator light flashes.
NOTE:
Erasing all channels should only be performed
when programming HomeLink for the first time.
Do not erase channels when programming addi-
tional buttons.
32
Identifying Whether You Have A Rolling Code
Or Non-Rolling Code Device
Before programming a device to one of your
HomeLink buttons, you must determine whether
the device has a rolling code or non-rolling code.
Rolling Code Devices
To determine if your device has a rolling code, a
good indicator is its manufacturing date. Typically,
devices manufactured after 1995 have rolling
codes. A device with a rolling code will also have
a "LEARN" or "TRAIN" button located where
the antenna is attached to the device.The button
may not be immediately visible when looking at
the device. The name and color of the button
may vary slightly by manufacturer.
NOTE:
The "LEARN" or "TRAIN" button is not the
button you normally use to operate the device.
Non-rolling Code Devices
Most devices manufactured before 1995 will not
have a rolling code. These devices will also not
have a "LEARN" or "TRAIN" button.
Programming HomeLink To A Garage Door
Opener
To program any of the HomeLink buttons to
activate your garage door opener motor, follow
the steps below:
NOTE:
All HomeLink buttons are programmed using this
procedure.You do not need to erase all channels
when programming additional buttons.
1. Place the ignition switch into the ON/RUN
position.
2. Place the garage door opener transmitter 1 to
3 inches (3 to 8 cm) away from the HomeLink
button you wish to program, while keeping the
HomeLink indicator light in view.
3. Push and hold the HomeLink button you want
to program while you push and hold the
garage door opener transmitter button you
are trying to replicate.
4. Continue to hold both buttons and observe
the HomeLink indicator light. The HomeLink
indicator light will flash slowly and then rapidly.
Once this happens, release both buttons.