Table of Contents
Advertisement
Cordless Framing Nailer
User Manual
[Revision 4.0 April 2017]
READ THIS MANUAL CAREFULLY BEFORE USE AND KEEP FOR FUTURE REFERENCE – FAILURE TO DO SO MAY
RESULT IN INJURY, PROPERTY DAMAGE AND MAY VOID WARRANTY. • Products covered by this manual may vary in
appearance, assembly, inclusions, specifications, description and packaging.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Unimac NALFRMUMCACB5
Summary of Contents for Unimac NALFRMUMCACB5
- Page 1 Cordless Framing Nailer User Manual [Revision 4.0 April 2017] READ THIS MANUAL CAREFULLY BEFORE USE AND KEEP FOR FUTURE REFERENCE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY VOID WARRANTY. • Products covered by this manual may vary in appearance, assembly, inclusions, specifications, description and packaging.
-
Page 2: Table Of Contents
Cordless Framing Nailer Table of Contents Safety ................................. 1 Operation ................................2 Description ..............................2 Air supply ..............................2 Loading fastener and operation ........................2 Maintenance ..............................3 Troubleshooting ............................3 Technical Specifications ........................... 4 E&OE © 2017 Unimac... -
Page 3: Safety
NEVER USE A TOOL that is leaking air, had missing or damaged parts or requires repair and make sure all the screws and securely tightened. • MAKE DAILY INSPECTION FOR FREE MOVEMENT of trigger, safety mechanism and spring to insure the tool can operate well. • ONLY USE PARTS AND ACCESSORIES recommend by manufacturer. E&OE © 2017 Unimac... -
Page 4: Operation
Hold gun body firmly and press safety stand on workpiece where fastener is to be applied. Pull the trigger to drive fastener into workpiece. 8. This operating procedure provides rapid-fire fastener driving. Never operate tool unless safety stand is in contact with workpiece. E&OE © 2017 Unimac... -
Page 5: Maintenance
2. Place 2 or 6 drops of oil into air 2. Inadequate lubrication. inlet. 3. Worn or damaged O-rings or seals. 3. Check and replace O-rings or seal. 4. Exhaust port in cylinder head is blocked. 4. Replace damaged internal parts. E&OE © 2017 Unimac... -
Page 6: Technical Specifications
3. Magazine or nose screw loose. 3. Tighten the magazine. 4. Magazine is dirty. 4. Clean the magazine. Technical Specifications Capacity 80pcs Nail length 50mm - 90mm Operation pressure 80-120PSi (5.5-8.3bar); Max = 120PSI (8.3bar) Air inlet ¼”N.P.T. Weight E&OE © 2017 Unimac... - Page 7 ©2017 Unimac. All rights reserved. No part of this document, including descriptive content, concepts, ideas, diagrams or images may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying, scanning or recording, or any information storage and retrieval system, without express permission or consent from the publisher.
Need help?
Do you have a question about the NALFRMUMCACB5 and is the answer not in the manual?
Questions and answers