If Paint Is Used; Plastic Mold Tooling; Plastics Flammability; Texture/Glossing Of Housing - Philips 220E1SB/00 Service Manual

If paint is used

•
RoHS required
•
WEEE require
•
If new painting type needs to implement, refer to UN-D 1235.

Plastic mold tooling

•
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines, gate
marks, ejector marks, etc.). Refer to "TYV61-90007".
•
Painting to cover up cosmetic defects due to molding is strongly discouraged.
•
China RoHS mark requested.

Plastics flammability

•
All Plastics to be Flame Retardant UL 94-HB.
•
Base / Rear to be Flame Retardant UL 94-HB
•
All major plastic parts (bezel, back cover) need to be molded from same resin
•
Plastic resin type selection should be referred to "plastic-Philips Pool monitor"

Texture/Glossing of housing

•
The texture area and texture no should follow Philips make-up sheet.
•
The exterior surfaces shall have a uniform texture.
•
Philips must approve the mold texturing.
•
Detail document for texture refer to "UN-D249", "UN-D 600".
•
> = 80 gloss units

Tilt and swivel base

• : -5 ° +2/- 0 ° (forward)
Tilt angle
+20 °+0/- 2 ° (backward)
•
Tilt for left and right:
︱A-B︱≤4.0MM
•
Black side and cut side：
L
•
Gap between bezel and rear cover
•
Step between bezel and rear cover
•
"Wobble", "Twist", etc (front to back or side to side)
Whole monitor set shall retain stability within a short time after the applied external force disappears.
20NT , 6secs（Max.） back to stable.
U
R
D
0.4 mm (Typ.)
Left, right and top: ≤0.6mm
A
1. Visual area
H：｜L-R｜≤1.5mm
V：｜U-D｜≤1.5mm
2. Black side on the left and right is
symmetrical, not cut side.
Bottom and corner: ≤1.1mm
Meridian 1 91
B