Installing/Replacing Seat Positioning Straps; Installing; Replacing - Invacare Spree XT Owner's Operator And Maintenance Manual

SECTION 6—BACK/SEAT

Installing/Replacing Seat Positioning Straps

NOTE: For this procedure, refer to FIGURE 6.6.

Installing

1. Remove the hex screw and locknut that secures the back cane to the back plate.
2. Position the seat positioning strap against the back plate.
3. Install the hex screw through the seat positioning strap, coved spacers and back cane.
4. Securely tighten the seat positioning strap to the wheelchair with the locknut.
5. Repeat STEPS 1‐4 for opposite side.

Replacing

1. Remove the hex screw, locknut and seat positioning strap from the back plate of the
wheelchair frame.
2. Discard existing seat positioning strap.
3. Install the new seat positioning strap to the wheelchair. Refer to Installing on page 57.
Back Plate
Back Cane
Locknut
Seat Positioning Strap
Coved Spacers
Hex Screw
FIGURE 6.6 Installing/Replacing Seat Positioning Straps
57
Part No 1118364 Spree XT