Advertisement
Possible cause
Computer communication baud rate
too high
Other condition as shown by the LED
indicator
Adapter does not print
Possible cause
No film in printer (flashing orange
adapter LED)
Direct Connect adapter not properly
connected to camera and printer
Camera not powered on
Camera not in Connect mode
Solution
Manually select a low baud rate:
At the main window, click
the Settings button.
On the Baud Rate list,
click 19200 or 9600.
Click the OK button.
See Computer connection codes
(page 25).
Solution
Insert a new pack of film (Figure 9 on
page 20).
Check the connections as described
on page 18, and verify that the
adapter LED and the printer LED are
both on.
Verify that the camera is on. See the
camera instructions if necessary.
Verify that the camera is in the Con-
nect mode before pressing the print
button on the adapter. See the camera
instructions if necessary.
23
Advertisement
