Inverter Power Supply (U); Temperature Thermistor; Oven Circuit Breaker - Panasonic NN-CS597S APH Service Manual

NN-CS597S
7.5.

Inverter power supply (U)

DO NOT try to REPAIR H.V. Inverter power supply (U).
Replace complete H.V. Inverter(U) Unit.
WARNING: HIGH VOLTAGE
Test if failure codes H95, H97 or H98 appear when performing
the following procedure. It is recommended to use an AC line
input current ammeter for testing.
Test 1
1. With the oven unit's AC power supply cord is unplugged
from the wall outlet, unplug the 2 pin H.V. connector CN703
from the magnetron tube.
2. Place 1 liter of water load into oven cavity.
3. Plug in the oven's AC power supply cord into outlet.
4. Program DPC.
a. Press Timer/Clock pad twice.
b. Press Start button once.
c. Press Microwave pad once.
5. Program oven at High power for 1 minute and press [Start]
button.
a. After approximately 37 seconds, oven stops operating.
b. During oven
approximately 0.5 to 1A. If both a and b are OK,
proceed to test 2.
INPUT CURRENT
Unplug CN703
Test 2
Continued from Test 1
1. Unplug the oven's AC power supply cord from outlet.
2. Unplug 3 pin connector CN701. CN703 remains unplugged.
3. Plug in the oven's AC power supply cord into outlet.
4. Program DPC.
a. Press Timer/Clock pad twice.
b. Press Start button once.
c. Press Microwave pad once.
operation, the input current
FAILURE CODE
0.5 to 1A Oven stops in 37
seconds after started.
5. Program oven at High power for 1 minute and press [Start]
button.
a. After approximately 3 seconds, oven stops operating.
b. During oven
approximately 0.4A.
Unplug CN701
If both a and b check OK, the Inverter Power Supply (U) can be
determined to be OK.
7.6.

Temperature thermistor

These sensor monitors the heat produced by the heater circuit
and maintains the magnetron temperature which user had
selected. Normal room temperature 10°C to 30°C, the reading
across the temperature thermistor should be as follows.
TEMP MAGNETRON
THERMISTOR
100°C 30-60KΩ
25°C 700K-1.5MΩ
If the resistance reading is out of the range stated here, the
thermistor is detective and must be replaced.
7.7.

Oven circuit breaker

1. Turn the switch of oven circuit breaker to the "I" position and
then plug in the oven.
2. Press the "TEST" button on oven circuit breaker, if the
switch jump back to "O" position, you may decide the oven
circuit breaker functions properly.
is
24
operation, the input
INPUT CURRENT FAILURE CODE
0.4A Oven stops in 3
seconds after started.
STEAM HEATER
THERMISTOR THERMISTOR
10-20KΩ
100K-300KΩ 100K-300KΩ
current is
OVEN
10-20KΩ