Stopping/Parking - Wacker Neuson RD 12A Operator's Manual

RD 12A

4.19 Stopping/Parking

See Graphic: wc_gr002953
4.19.1 Stop the machine on a flat surface with a suitable load bearing
4.19.2 Turn the vibration off by pressing the vibration control button (10) on
4.19.3 Press the water spray switch to the OFF position (61).
4.19.4 Set the forward/reverse control (15) to the NEUTRAL position.
4.19.5 Return the engine throttle to idle by pressing the lower half of the
4.19.6 Set the parking brake (42). To set the parking brake, pull the brake
4.19.7 Stop the engine by turning the ignition switch (55) to the OFF position.
WARNING
wc_tx001071gb.fm
capacity.
the forward/reverse lever (15).
throttle switch (54) and allow the engine to cool down.
lever up until the brake pad engages the drum. To release the brake,
lower the brake lever. Always set the parking brake before leaving the
machine.
Note: The parking brake engages the rear drum only.
If the vehicle constitutes a hazard or obstacle to traffic when parked, it
should be marked with signs, lights, and other warnings.
If the machine must be parked on a sloping surface, chock the drums
with wedges to prevent any vehicle movement.
55
54
61
F N
R
10
15
42
wc_gr002953
41
Operation