Setting Command Overview - Seiko SmartCS NS-2250 Command Reference Manual

2.1 Setting command overview

2.1 Setting command overview
This section gives a list of setting commands that can be used on the NS-2250.
Class
System setting
mands
bonding setting com-
mands
ipinterface setting com-
mands
IPv6 setting commands
IP host setting com-
mands
IP route setting com-
mands
IPv6 route setting com-
mands
ipfilter setting
mands
ipsec setting commands
Table 2-1: Setting command list
Command
com- set hostname
set ipaddr
unset ipaddr
set tcpkeepalive
set bonding up delay
enable bonding
disable bonding
set ipinterface mtu
create ip6
set ip6addr
unset ip6addr
delete ip6
create ip host
delete ip host
create ip route
delete ip route
create ip6route
delete ip6route
com- create ipfilter
delete ipfilter
delete ipfilter line
delete ipfilter allentry
enable ipfilter
disable ipfilter
create ipsec secret psk
delete ipsec secret psk
set ipsec conn auto
set ipsec conn leftid
set ipsec conn left
set ipsec conn leftsubnet
Description
Configure the NS-2250 host name.
Set the NS-2250 IP address.
Unset the NS-2250 IP address.
Set the TCP keepalive time for the NS-2250.
configure the wait timer which is the delay pe-
riod enabling slave interface after the detec-
tion of physical linkup.
Enable the bonding function.
Disable the bonding function.
Set the MTU of each interface.
Enable the IPv6 communication function.
Set the NS-2250 IPv6 address.
Unset the NS-2250 IPv6 address.
Disable the IPv6 communication function.
Register a pair of a host name and an IP ad-
dress (host entry).
Delete the host entry.
Create a static route to an IP address.
Delete the static route.
Create static routes for IPv6.
Delete the static route.
Register the filter conditions.
Delete the registered filter conditions.
Delete the registered filter condition by spec-
ifying a line number.
Delete all filter conditions.
Enable the filter function.
Disable the filter function.
Register a pre-shared key used in the IKE.
Delete a pre-shared key used in the IKE.
Set initiator or responder of key exchange.
Set the ID of the security gateway of own side.
Set the IP address of the security gateway of
own side.
Set the network address of own side which
communicates under encrypted by using
IPsec.
17
Chapter 2 Command list
Continued on next page