Page 1
Before using this console server, carefully read this installation manual so you can use the console server correctly. After reading this manual, store it in a safe place so can be accessed easily when necessary. Package contents Check the contents of package containing the NS-2250. M4x10 screw M5×10 screw Left Right...
Safety precautions Before using the NS-2250, carefully read these safety precautions so you can use the console server safely. In this manual, the following symbols are used to call your attention to precautions so that you can use the NS-2250 safely and prevent damage to equipment.
Page 3
If metal pieces or water or other liquids enter the interior or gaps of the NS-2250 If the NS-2250 has been dropped or the exterior surface of the NS-2250 has been damaged Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous condition is not achieved due to uneven mechanical loading.
Page 4
These actions can cause fire, electric shock, accident, or malfunction. Do not place objects on the NS-2250. Do not apply impact to the NS-2250 with blows or other similar actions. Do not place the NS-2250 in an unstable location.
NS-2250 is not guaranteed. While the NS-2250 is running normally, do not cut the power of the NS-2250 by switching off the power switch or pulling out the power cable, or press the RESET switch.
Page 6
SSOL. Title to and all intellectual property rights in accompanying documentation are vested in SSOL. PERMITTED USES You may use the Program on any SSOL’s NS series product owned by you in the authorized use of the Program described on the user manual. RESTRICTIONS You may not, except as otherwise provided on the user manual, (a) make copies of the Software or any portions thereof.
Connect to the CONSOLE port Use the CONSOLE port to set up the NS-2250 and output log information of the NS-2250 and other console messages. The CONSOLE port is a DTE port. Its specifications are different from the serial ports of the NS-2250.
Page 8
“SEIKO” is a registered trademark of Seiko Holdings Corporation. Ethernet is a registered trademark of Fuji Xerox Co., Ltd. Seiko Solutions Inc. is not responsible for damages caused by this manual or the use of products described in this manual or the expenses necessary to compensate for such damages.