Setting Pan And Tilt Electronic Limit Stops; Figure 3-6 Front Panel Of Positionit Rack Mount Controller; Figure 3-7 Front Panel Of Positionit Rack Mount Controller - Will Burt Position It RACK MOUNT CONTROLLER Operator's Manual

P I R M
OSITION T ACK OUNT
To set the Unstow Position:
1. Manually drive the positioner into the position required for unstowing
2. Press and hold the Pan and Tilt "Left" and "Right" buttons at the same time, then, press
the "Unstow" button and hold all three for (3) seconds (Figure 3-6).
3. The unstow position is now set.
It is advised that the Unstow position is tested after being set to ensure it been programmed
correctly.

3.7 Setting Pan and Tilt Electronic Limit Stops

The positioner uses electronic limit stops. The positioner does not have mechanical hard stops.
The positioner comes from the factory with electronic limit stops set to the maximum
recommended pan and tilt. The limit stops can be adjusted through the controller, but it is not
possible to remove the limit stops completely.
To set the electronic limit stops:
1. Connect the default joystick controller (P/N: 5098901) to the control connector
(Figure 3-7).
Control Connector
2. Set the electronic limit stops according to the operator's manual (Section 1.3).
3. Remove the default joystick controller.
4. Verify the electronic limit stops.
3-4
C
ONTROLLER

Figure 3-6 Front Panel of PositionIt Rack Mount Controller

Figure 3-7 Front Panel of PositionIt Rack Mount Controller

Unstow
Left Right
TP-5362301-B
July 2017