Operation - Ozito MPS-8000 Instruction Manual

OPERATION

4. CONTROLS
CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK,
A RESIDUAL CURRENT DEVICE (RATED 30MA OR LESS)
MUST BE USED.
On/Off Switch
1 To turn the unit on press
the on/off button down into
the on position.
2 To turn the unit off press
the on/off switch again.
Variable Spray Trigger
1 Squeeze the on/off trigger
to start spraying.
Note: The further the trigger is pulled back, the more spray.
Spray Regulator Dial
The regulator dial is a stop that limits the distance the trigger
can be pressed. This results in less material being sprayed.
1 Squeeze the trigger
while aiming at a piece of
cardboard or scrap.
2 Release the on/off trigger
to stop spraying.
2 Rotate the regulator dial
to the required position for
optimal results.
5. HOW TO SPRAY
WARNING: NEVER UNDER ANY CIRCUMSTANCES AIM THE
NOZZLE AT ANOTHER PERSON OR ANIMAL. THE HIGH
PRESSURE AT THE NOZZLE COULD CAUSE INJURY.
CAUTION: PROTECTIVE CLOTHING SHOULD BE WORN
DURING OPERATION TO AVOID INJURY.
1 Ensure the suitable nozzle
and fluid needle is fitted for
the paint viscosity.
3 Start away from your
workpiece and evenly
control the speed
of movement while
maintaining distance and
angle to the piece.
2 Spray onto scrap material
to check that the spray
pattern is correct.
4 Overlap each stroke by
2cm to achieve an even
coat.
MPS-8000